This tutorial demonstrates a black finish vinyl wrap applied to a 1997-2004 Chevrolet Corvette bumper. The video shows how to make a complex bumper installation manageable by dividing the surface into two main sections rather than wrapping it in a single stretched piece. Placing a clean seam along the factory body line keeps the vinyl stable and helps prevent panel failure.
Installation Steps
The installer walks through the following process to complete the bumper wrap:
- Run knifeless tape along the body line to divide the bumper into two workable sections.
- Roll out the main flat section, glass out both sides, and work the material from the center outward.
- Pull the knifeless tape and trim away the excess vinyl along the first section.
- Apply a second line of knifeless tape on the body line just past the existing seam.
- Position the top section, glass both sides, work outward, apply heat to glass down the bottom area, and pull the tape.
Aura Vinyl vinyl wrap is a cast polymer hybrid film featuring German-made adhesive designed for repositioning and smooth installation.
FAQ
Why use a seam when wrapping a Chevrolet Corvette bumper?
Using a seam along the factory body line helps prevent the vinyl from lifting or failing over time. It allows the installer to wrap difficult bumper curves in two manageable sections.
How do you apply vinyl wrap to the Corvette bumper sections?
The installer glasses out the material on both sides and works from the center outward. Knifeless tape placed along the body line creates a clean cut without using a knife on the car.
How do you wrap the lower portion of the bumper?
The installer warms the material with heat to glass it down onto the lower recessed area before pulling the knifeless tape to remove excess film.