This video shows a blue vinyl wrap installation on a 1997 to 2001 Audi S4 bumper. Two installers work together to stretch, glass out, and set the material across the panel.
Step-by-Step Bumper Wrapping
Wrapping a curved rear bumper is easier with a partner. One person holds tension at the end of the film without pulling too hard while the other installer applies heat. Once the heating step is done, the lead installer pulls up and down while the partner pulls out and toward themselves. This cooperative movement glasses out the material, removing wrinkles across the surface.
After a section is glassed out smoothly, tack it down in the center. Repeat this heating, pulling, and tacking sequence progressively until you reach the outer edge of the bumper. Once the panel is flat and secure, cut the excess film down to shape to complete the install.
About the Film
Aura Vinyl vinyl wrap features a PET backing that creates a smooth finish with minimal orange peel, paired with German adhesive for easy repositioning during tough bumper installs.
FAQ
How do you glass out vinyl wrap on a bumper?
Have one person hold light tension while the other heats the film. Then, pull up and down while your partner pulls out and toward themselves before tacking the center.
Why should you wrap a bumper with a partner?
Working with a partner allows you to maintain even tension and stretch the material across complex curves without overstretching.