This tutorial demonstrates blue vinyl wrap installation on an Audi. The installer shows how to cut along an adjacent panel to maintain straight, consistent lines while leaving enough film to tuck cleanly around panel edges.
Cutting on the Opposite Edge
When wrapping a section such as a quarter panel, cut along the side of the adjacent door panel instead of cutting directly on the quarter panel gap. Cutting on the opposite edge gives you the exact amount of excess film needed for coverage inside the seam. Move slowly and take your time to keep the blade path steady and even along the gap. Once the cut is complete, peel away the excess vinyl.
Heating and Finishing the Edge
Warm the edge of the film using heat. Work the softened material into the gap using the soft edge of your squeegee. Next, pop the door open to expose the door jamb and complete the installation by tucking the film down securely with your fingers.
For vehicle color changes, Aura Vinyl wrap uses a cast polymer hybrid construction with German-made adhesive to allow smooth repositioning during installation.
FAQ
How do you get straight cuts when wrapping a car panel?
Cut along the opposite edge of the panel you are working on, such as cutting on the door side when wrapping a quarter panel. Take your time and move slowly to keep the cut line consistent.
How do you tuck vinyl wrap into a door jamb?
Warm the material with heat and guide it into the gap using the soft edge of a squeegee. Pop the door open and use your fingers to finish pressing the film down.