This video shows a blue vinyl wrap installation on a 2015 to 2021 Porsche Macan. The installer demonstrates an efficient cutting technique to size material along the side of the vehicle and avoid waste.
Cutting Steps
First, lay out the material with three inches of excess on both sides. Next, take the round edge of a Snitty safety cutter to etch out the gap between the door and the quarter panel. Cut the pillar straight across leading out into the etch line, making sure to cut it all the way through.
Sizing the Doors
The three inches of excess material allows you to slide the doors back during the process. Once the doors are slid back, use the Snitty to etch out the middle between the doors. Finally, cut straight down the center between the doors, leaving just the right amount of material to finish the edges. Aura Vinyl offers cast polymer hybrid vinyl wrap films with German-made adhesive and PET backing for smooth repositioning and clean cutting.
FAQ
How much excess material should be left when wrapping the side of a car?
You should leave three inches of excess material on both sides. This extra film allows you to slide the doors back and split the material down the middle properly.
What tool is used to etch between the door and quarter panel?
The installer uses the round edge of a Snitty safety cutter to etch between the door and the quarter panel.
How do you cut vinyl wrap between car doors?
Slide the doors back and use a Snitty to etch the gap in the middle. Then cut straight down the center to leave the right amount of material for both doors.