This tutorial demonstrates dark grey vinyl wrap applied to a 2017 to 2023 Tesla Model 3 front fender.
The demonstration highlights how an installer manages tension and backing paper on a contoured front panel. By breaking the fender into distinct upper and lower sections, the material goes on smoothly without excessive stress.
Fender Wrap Steps
- Cut the vinyl down to shape, pull the backing from the front edge, and tack down the front side.
- Pull the backing down, tack the top corner, and cut off the excess backing from the bottom.
- Lift up the front portion, glass the sheet flat, and work out the entire top section starting from the center.
- Pick up the bottom section, apply heat, and glass out the entire lower area before squeegeeing.
- Cut the film down to shape and remove the excess material.
Film Features
Aura Vinyl wrap uses a cast polymer hybrid construction with German-made adhesive to allow repositioning and fewer glue lines. Its PET-backed finish also delivers a flat look with reduced orange peel.
FAQ
How do you glass out vinyl wrap on a fender?
Lift the loose vinyl away from the panel, apply heat to soften the material if needed, and pull it evenly until all wrinkles disappear before squeegeeing.
Where should you start squeegeeing on a Model 3 fender?
Once the top portion is glassed down, start squeegeeing in the center and work out the entire upper section toward the edges.
Why is backing paper removed in sections?
Removing backing paper in stages helps anchor specific corners first and keeps the adhesive from grabbing unwanted panel areas before the film is stretched flat.