This install guide demonstrates wrapping the gas cap on a silver 2002 to 2008 Audi A4. The video shows how to install vinyl around a fuel door cleanly without lifted edges or wrinkles.
Gas Cap Wrapping Technique
To begin, lay out and squeegee the material down over the panel. Heat the area around the gas cap, then take a finger to lock in the opposite edge all the way around the fuel door. Make a slow, consistent, straight cut through the vinyl and remove the excess material.
To avoid wrinkles, avoid starting on the straight section of the door. Instead, start on the curved section. Apply heat to the material and use a flexible squeegee to set the curve firmly.
Finishing the Edges
Next, pop the gas cap open. Apply a little bit of heat and start rolling the vinyl over the curved corner. Ensure the backside of the fuel door is prepped so the film adheres properly. Following these steps leaves a clean edge that will not peel or look crusty.
Aura Vinyl produces vinyl wrap with a cast polymer hybrid construction and German-made adhesive for easy repositioning.
FAQ
How do you avoid wrinkles when wrapping a gas cap?
Avoid starting on the straight section and begin on the curved section instead. Apply heat and use a flexible squeegee to set the curve.
How do you prevent wrap edges from lifting around a fuel door?
Make sure the backside of the fuel door is prepped before wrapping. Lock in the edges with heat and roll the material over the corners after popping the cap open.