This video shows a gloss black vinyl wrap installed on the roof of a 2002 to 2006 Acura RSX. The demonstration outlines how to position and glass vinyl across a large roof surface without fighting wrinkles. To begin the installation, lift the vinyl from one side and glass it out across the panel. Next, glass the material outward toward each corner to establish proper tension. Repeat this same glassing technique on the other side of the vehicle, addressing each corner separately. If small parallel wrinkles appear along the sides, gently lift the material up from the bottom edge and pull them out. After the sheet is fully glassed, begin squeegeeing starting directly from the center of the roof. Work outward toward the sides using overlapping squeegee strokes to push air out smoothly. As you approach the corners, pick the material up slightly to give trapped air an exit route. Aura Vinyl vinyl wrap features a PET-backed finish with German-made adhesive, offering an expected lifespan of 3 to 5 years under proper care.
FAQ
How do you remove wrinkles when wrapping a car roof?
If you see small parallel wrinkles, pick the material up from the bottom edge and pull them out before squeegeeing.
Where should you start squeegeeing roof wrap?
Start squeegeeing from the center of the roof and use overlapping strokes working outward. When reaching corners, pick the material up slightly to let trapped air escape.