This project features a green vinyl wrap installed on a 2007-2013 BMW M3. In the video, an installer applies heat with a heat gun and stretches green vinyl wrap around the rear bumper and quarter panel of the vehicle.
Five tips for a clean install
The clip highlights five steps for wrapping panels cleanly:
- Clean the edges: A panel might look clean, but edges must be degreased properly or the vinyl will lift.
- Position knifeless tape carefully: Place tape strategically so you leave enough extra film to wrap behind the panel edge.
- Squeegee with a plan: Do not force wrinkles toward edges. Lift the film, relax the material, and change your squeegee direction.
- Do not over-stretch: Excessive tension can make the film shrink back or lift after installation.
- Post-heat edges: Heat the edges and apply pressure so the adhesive settles securely.
Film details
Aura Vinyl vinyl wrap features a PET backing that creates a smooth finish with less orange peel. The cast polymer hybrid film includes German-made adhesive to help with repositioning and to reduce glue lines during installation.
FAQ
Why is post-heating edges important on a vinyl wrap?
Post-heating edges helps the adhesive settle and reduces the risk of the vinyl lifting later. Apply heat and firm pressure directly to the wrapped edge after laying the material.
What happens if you over-stretch vinyl wrap?
Over-stretching adds excessive tension to the film. This tension can cause the vinyl to shrink back or lift off the car over time.
How do you prevent vinyl wrap from lifting around panel edges?
Thoroughly clean and degrease every edge before wrapping. Leave enough vinyl to wrap completely behind the panel and post-heat the edges with firm pressure.