This tutorial shows a green vinyl wrap installed on the tailgate of a 2016 to 2023 Toyota Tacoma. The installer demonstrates how to lay the film into the stamped tailgate letters cleanly without trapping air bubbles.
Tailgate Recess Install Steps
Installing vinyl across stamped lettering requires a specific order of operations:
- Squeegee the film evenly down across the flat panel until reaching the top edges of the letters.
- Heat the vinyl material evenly with a heat gun.
- Let the film cool for a few seconds before touching it or pushing it into the recesses.
- Work each letter individually, moving from the center outward.
- Feed the vinyl into the recesses patiently without stretching or forcing it into place.
Tips for Clean Results
Rushing the letters often leads to air pockets or overstretched vinyl. If this is your first attempt at wrapping recessed letters, take your time because it can take a couple tries to get the technique right. Keeping steady tension and feeding the film naturally prevents tension pull-back later.
Aura Vinyl produces cast polymer hybrid vinyl wrap engineered with German-made adhesive and PET backing to help installers achieve flat finishes on complex body panels.
FAQ
How do you wrap recessed letters without bubbles?
Squeegee the vinyl down to the top edge of the letters, apply heat, and let it cool for a few seconds. Then, feed the material into each letter individually from the center outward without forcing it.
How long should you wait after heating vinyl before feeding it into recesses?
You should let the material cool for a few seconds after applying heat before feeding it into the recessed letters.
What vehicle is featured in this tailgate wrap tutorial?
The tutorial features a 2016 to 2023 Toyota Tacoma tailgate wrapped in green vinyl.