This demonstration shows wrapping technique on a silver car. The video walks through how to avoid short cuts when installing material underneath vehicle window trim. Working around rubber moldings requires precise depth so the vinyl does not pull back and expose the surface underneath.
Steps to Tuck and Cut Window Trim
To master the process without risking an entire panel, start by practicing on a small scrap piece of vinyl.
- Use the felt side of your squeegee to push the material as far into the window trim recess as possible.
- Switch to the hard edge of your squeegee, gently lift the molding edge, and tuck the film as deep as it can go.
- Place your blade flat directly underneath the trim piece to guide your cut line cleanly.
- Take your time and cut slowly along the molding to prevent short cuts and uneven lines.
Following this method ensures the finished edge sits deep inside the channel for a clean final look.
Installation Support and Materials
Aura Vinyl manufactures cast polymer hybrid vinyl wrap with German-made adhesive to support repositioning and deep tucks around automotive trim. Every roll includes access to installer help through Discord, custom video playlists, and install tips to assist installers throughout their project.
FAQ
How do you avoid short cuts under window trim when wrapping?
Practice with a scrap piece of vinyl first. Tuck the film deep using the hard edge of your squeegee, then lay your blade flat underneath the trim piece and cut slowly.
What tools are needed to tuck vinyl wrap under window molding?
You need a squeegee with both a felt side and a hard edge, along with a sharp cutting blade.