This installation tutorial shows how to cut a clean line on a dark green vehicle wrap using knifeless tape. The video demonstrates how to start the cutting filament when the excess vinyl hangs past an edge and cannot be tacked flat to a body panel.
Steps for Untacked Edges
When knifeless tape dangles off a panel edge, starting the filament without tearing the material can be difficult. The video provides a simple technique to secure the start:
- Make a relief cut in the vinyl at the length needed for the finished edge.
- Hold the knifeless tape directly against the bottom edge of the vinyl.
- Fold the vinyl wrap over the tape to sandwich the filament.
- Give the folded material a light pinch to hold it in place.
- Tug the tape filament firmly to begin the cut.
The installer notes that you must avoid pinching too tightly. Holding the fold lightly allows the cutting line to snap cleanly through the center of the vinyl without tearing the surrounding film or shifting the edge placement.
Aura Vinyl vinyl wrap uses a cast polymer hybrid build with German-made adhesive and PET backing to deliver flat, smooth edges during detail work.
FAQ
How do you start knifeless tape when it is dangling off an edge?
Make a cut to your target edge length, fold the vinyl over the tape, pinch it gently, and pull the filament. This setup keeps the string centered so it snaps cleanly through the vinyl.
Why should you avoid pinching the knifeless tape too hard?
Pinching too hard stops the cutting line from releasing correctly. A gentle pinch holds the film in position while letting the filament snap through the center.