This tutorial demonstrates proper vinyl wrap installation on the wheel well of a red car.
The video shows an installer correcting a common beginner wrapping mistake. Leaving loose film inside the wheel well can cause the film to flap around during driving. The clip shows how to seal the film securely into the body seam before making a clean cut.
Wheel Well Trimming Steps
To achieve a clean finish on fender edges, use these steps shown in the demonstration:
- Heat the vinyl material thoroughly to make it pliable.
- Run your finger as far into the edge as possible to seat the film.
- Verify full coverage without leaving too much excess material bunched inside.
- Rest your knife blade on the furthest part of the edge.
- Cut away the excess material in a smooth line.
Working with Aura Vinyl
Aura Vinyl vinyl wrap features a cast polymer hybrid build with German-made adhesive. The PET backing provides a smooth surface with reduced orange peel, while the adhesive supports repositioning when working edges into tight curves. Installers can also access installation advice on Discord and through Wrap Academy educational videos.
FAQ
Why is excess vinyl in the wheel well a problem?
Beginners often leave excess material in the wheel well, which causes the vinyl to flap around. Trimming it down properly keeps the edge secure while maintaining full surface coverage.
Where should you cut vinyl on a wheel well edge?
After heating the material and pressing it deep into the edge with your finger, lay your blade flat on the furthest part of the edge to trim away the leftover film.