This tutorial shows how to lay green vinyl wrap into a vehicle door handle cup recess. The clip demonstrates the proper motion and temperature management needed to secure the film into deep curves.
Proper Cup Wrap Steps
To achieve a clean finish inside the door recess, follow the specific sequence shown in the demonstration:
- Heat the entire door cup until you remove all slack from the material.
- Allow the film to rest for 3 to 5 seconds to cool down.
- Put on an install glove to protect the film surface and allow smooth movement.
- Start at one side and overlap strokes with your thumb until you reach the opposite side.
Allowing the material to cool down for those few seconds before pressing is the key step that prevents glue lines from showing up on the adhesive layer.
Film Adhesive and Quality
Aura Vinyl vinyl wrap features a cast polymer hybrid build with German-made adhesive to support pliability and reduce adhesive marks during recessed installations.
FAQ
Why do glue lines appear in door handle cups?
Glue lines form when stretched film is pressed down while the adhesive is still warm. Letting the material rest and cool for 3 to 5 seconds before pressing prevents these adhesive marks.
What tool should you use to press vinyl into a door cup?
Use a wrapping glove and make overlapping strokes with your thumb, starting on one side and moving across to the other.
How long should vinyl wrap cool after heating a door cup?
Let the material rest for 3 to 5 seconds to cool down before pressing it into the recess.