This tutorial demonstrates wrapping a silver Jeep Wrangler door panel with vinyl film. The video shows an installer working on the lower door section to lay the material flat without creating wrinkles or stretch marks.
Wrinkle Prevention Technique
Attempting to squeegee the material directly without tension leaves heavy wrinkles on the panel. To avoid this problem, start by picking your section of film up from the vehicle surface. Hold downward tension on the sheet while heating the material with a heat gun. Once the vinyl is warm enough, push more downward tension on the sheet. Applying this downward pull forces all the wrinkles off the panel surface.
Squeegee Application Steps
Allow the vinyl to cool down for a few seconds before you begin squeegeeing. Letting the material cool ensures there is no discoloration or stretch lines on the finish. Squeegee straight down while overlapping your strokes sideways to prevent catching wrinkles. Repeat this exact process across the rest of the door panel by holding tension, heating the film, pulling downward, and squeegeeing after it cools.
Aura Vinyl cast polymer hybrid film features German-made adhesive for repositioning and smooth handling on vehicle panels.
FAQ
How do you avoid wrinkles when wrapping a door panel?
Pick up the section of vinyl and pull downward tension while heating the material. The tension forces wrinkles off the panel before you lay it down.
Why should you let vinyl cool down before squeegeeing?
Allowing the vinyl to cool for a few seconds prevents discoloration and stretch lines. Squeegeeing while the film is overheated can damage the finish.