This wrap installation tutorial demonstrates a knifeless tape cutting technique on a black car. The video shows an installer preparing knifeless tape to release smoothly without losing grip on the edge.
Making a knifeless tape pull tab
Pulling knifeless tape can be tricky if the starting line slips from your fingers. The installer demonstrates a simple trick using leftover material to create a secure starting grip:
- Lift the edge of your knifeless tape up off the car.
- Take a tiny scrap piece of vinyl with the adhesive facing up.
- Tack down the edge of your knifeless tape onto the scrap.
- Fold the scrap piece over on itself to create a pull tab.
- Pull the tape all the way through just like normal and remove the excess.
This small handle gives your fingers a better grip on the knifeless tape so you can pull the filament through the vinyl steadily.
Vinyl installation support
Using knifeless tape helps installers trim panels cleanly without risking cut damage to the paint underneath. Aura Vinyl supports installers with tools, Discord installer help, and Wrap Academy classes to help you get clean results on every project.
FAQ
How do you make knifeless tape easier to pull?
You can make knifeless tape easier to pull by creating a pull tab from a tiny scrap of vinyl. Place the scrap adhesive-side up under the lifted tape edge, tack it down, and fold the scrap over itself.
Why use a vinyl scrap on knifeless tape?
The folded vinyl scrap forms a tab that gives you a much better grip when starting the cut. This allows you to pull the line cleanly through the film without slipping.