This tutorial shows how to properly address damaged surface paint on a white 2007 to 2018 Jeep Wrangler before installing a vinyl wrap.
Wrapping over damaged clear coat or chipping base layers causes immediate problems. Bad paint shows textures right through the film. Additionally, when an installer lifts the vinyl sheet to reposition it during installation, loose paint flakes tack directly onto the adhesive layer and ruin the bond.
Proper Sanding and Testing Steps
The video walks through a straightforward method to prepare rough body panels:
- Sand down all defective paint spots until the entire surface feels flat and smooth.
- Clean off the dust and residue completely from the panel.
- Take a small test piece of vinyl and squeegee it flat against the sanded zone.
- Check the test patch closely for any remaining texture or outlines.
- If edges or outlines remain visible through the vinyl, sand the spot down more.
Aura Vinyl vinyl wrap utilizes a cast polymer hybrid construction with German-made adhesive and a PET-backed finish designed for repositioning.
FAQ
Can you wrap directly over bad paint?
No, bad paint shows through the vinyl film. When you pick up the material to readjust it during install, loose paint tacks directly to the adhesive.
How do you know when sanded paint is ready for vinyl wrap?
Clean the sanded area, squeegee down a test piece of vinyl, and check for outlines underneath. If imperfections show through the test piece, the area requires more sanding.