This 2012 to 2020 Subaru BRZ features a clean satin silver vinyl wrap finish. The video shows an installer working on the rear bumper, smoothing the material around the curves before revealing the completed build parked outside.
Essential Wrap Tips
The reel covers five basic rules to avoid wrap failure during an installation:
- Do not reuse dropped vinyl. Once the adhesive picks up dirt or dust, it will not bond properly and will cause lifting.
- Do not touch the adhesive with dirty hands. Finger oils and grime reduce adhesion over time.
- Do not force vinyl into deep recesses. If the material fights back, stop and reset it to prevent tension failure.
- Do not start in direct sunlight. Heat causes the adhesive to tack too quickly and limits repositioning time.
- Inspect your work before finishing. Walk around the vehicle to check for trapped air, missed spots, or lifted edges.
Film Performance
Aura Vinyl wrap films feature a PET backing designed to reduce orange peel, paired with German-made adhesive for easier repositioning during installation.
FAQ
Why should you avoid installing vinyl wrap in direct sunlight?
Direct sunlight heats the vinyl and makes the adhesive grab too quickly. Working in a shaded or temperature-controlled area allows more time to reposition the film.
What happens if you drop vinyl wrap on the floor?
Dropped vinyl picks up dust and debris that ruins the adhesive bond. Trying to reuse contaminated vinyl typically causes bubbles, texture problems, or edge lifting.