This video demonstrates how to apply a green and white vinyl wrap with a PET-backed finish to a 1992-1999 BMW 3 Series (E36). The installer tackles a complex curved section on the front bumper and shows how to manipulate the material around tight corners without leaving wrinkles.
Bumper Wrapping Steps
- Tape off the upper piece and tack the vinyl wrap across the center.
- Make an angled relief cut six inches before the corner.
- Pick the material up, heat the sheet, and glass it around the bend.
- Heat the top wrinkles to let the material shrink directly to the corner.
- Tack the outer section, tuck underneath with the hard edge of a squeegee, and cut away the excess.
Handling Complex Curves
Relief cuts reduce surface tension before the film stretches around the corner. Heating the sheet relaxes the film so it shrinks naturally into the bend instead of overstretching. Aura Vinyl vinyl wrap features a cast polymer hybrid film with German-made adhesive that aids in repositioning and helps prevent glue lines during complex installs.
FAQ
How do you wrap a sharp bumper bend without wrinkles?
Make an angled relief cut six inches before the corner, heat the entire sheet, and glass the film around the bend. Heating the lifted vinyl allows wrinkles to disappear and lets the film shrink cleanly into the corner.
What tool is used to tuck the vinyl wrap on a bumper edge?
Use the hard edge of a squeegee to tuck the vinyl underneath the adjacent panel before trimming the excess film.