This tutorial shows how to wrap the rear quarter panel on a black Audi A5 Sportback using vinyl wrap. The video demonstrates a beginner-friendly method for installing vinyl on a quarter panel without tearing the backing or overstretching the material.
Step-by-Step Installation
Start by cutting the material with at least 2 to 3 inches of excess around all edges. Lay the panel onto the car carefully so the backing paper does not catch on edges and rip. Next, lift the entire rear section and peel the backing paper completely off.
Tack the film along the top body line to anchor it. Once anchored, glass out the bottom portion of the panel. You will notice a large pocket behind the rear window, which is normal. Lift the material and let heat pull the film into place, then smooth out any fingers along the edges.
Wrapping Without Overstretching
Heat the top portion of the quarter panel and work your way down to glass out the rear section. Always work the film gently. Pushing or pulling too hard can cause stretch marks or discolor the vinyl.
Aura Vinyl vinyl wrap uses a cast polymer hybrid film with German-made adhesive designed for clean repositioning and fewer glue lines.
FAQ
How much excess vinyl should you cut for a rear quarter panel?
Cut your material with at least 2 to 3 inches of excess around all edges before positioning it on the car.
How do you handle the large vinyl pocket behind the rear window?
A pocket behind the rear window is normal. Lift the material and apply heat to let the film pull itself into place, then smooth out the fingers along the edges.
What happens if you pull vinyl wrap too hard during install?
Overstretching the material can leave hard stretch marks or discolor the film.