This install features a chrome vinyl wrap on a 2013-2020 Subaru BRZ front fender. The installer demonstrates how to wrap the fender using chrome film step by step. First, lay the material over the fender and cut it down to rough shape. Starting at the front of the car, roll the backing paper toward the middle and tack the film down. Next, roll the backing paper down from the top side and trim away the excess backing paper so the bottom does not stick prematurely.\n\n## Installation Steps\n\nTo remove tension, pick the film up from the rear and glass it out across the panel. Repeat this by picking up the front of the fender and glassing it out. Once the film is flat, start in the middle and work all the trapped air out from behind the vinyl. If you see any wrinkles, apply a small amount of heat to relax the film, glass it out again, and work the wrinkles down.\n\nFor the bottom section of the fender, remove the remaining backing paper, add a little heat, and glass it down. Use a wrap glove to push out all the air from behind the vinyl. To complete the panel, cut away the excess material, remove the scraps, and tuck the edges cleanly behind the body lines. This install uses Aura Vinyl vinyl wrap, which features a cast polymer hybrid construction with German-made adhesive and a PET backing.
FAQ
How do you fix wrinkles when installing chrome wrap?
Apply a small amount of heat to the wrinkled area, glass the material out flat again, and work the vinyl down onto the panel.
How should you remove air during a chrome fender wrap?
Start in the middle of the panel to push trapped air outward, and use a wrap glove to smooth the vinyl along the bottom section.
What is the first step when wrapping a fender?
Lay the material out over the fender and cut it down to rough shape before peeling any backing paper.