This guide demonstrates how to replace badges on a green 1992 to 1999 BMW M3 during a vinyl wrap job. The video shows the step-by-step process of saving the factory emblem positions before wrapping and placing them back on afterward.
Making the Tape Template
To keep the badges in their factory position, start by placing masking tape around the entire emblem. Layer extra tape across the area so the template stays together when you pull it off. Using a marker, draw outlines showing exactly where the emblem sits inside the tape. Next, make marks along the edges of the car panel so you can align the template later. Carefully lift the tape template off the car and set it in a safe spot so it does not get damaged or lose its shape.
Emblem Removal and Reinstallation
Once the template is stored, remove the badges by cutting behind them with fishing line. Take a rubber wheel on a drill to erase any leftover adhesive foam from the paint surface. After you install your vinyl wrap on the panel, align the tape template back over the panel edges. Apply press-in-place adhesive to the back of the emblems, then set them directly onto the vinyl using your marker guides. After pressing the emblems down, pull away the tape template to complete the reinstallation.
Aura Vinyl vinyl wrap uses a PET backing and German-made adhesive for a flat finish that supports clean reinstallations.
FAQ
How do you save the factory position of car emblems before wrapping?
Create a tape template around the emblem, double up the tape, and mark the emblem and panel edges with a marker. Store the template safely so it keeps its shape until reinstallation.
What tool removes leftover emblem adhesive from car paint?
Use a rubber eraser wheel attached to a drill to clean away leftover adhesive residue after cutting the emblem off with fishing line.
How do you reattach emblems onto wrapped panels?
Apply press-in-place adhesive to the emblem backs, position the tape template back on the panel edges, and set the emblems into your marker outlines.
