This 2013 to 2020 Subaru BRZ features a metallic purple vinyl wrap finish.
The video shows installer @BRZADDY demonstrating how to cut a connected pillar, quarter panel, and side skirt from one sheet while saving excess material for the doors and another side skirt.
Cutting the Side Sections
To prepare your material without running short, follow these cutting steps:
- Lay out vinyl with three inches of excess on the front and rear.
- Cut the extra side skirt piece straight off the top edge.
- Etch a guideline between the door, side skirt, and quarter panel using the round edge of a Snitty tool.
- Cut the pillar as a straight piece because you can curve it to the roof bend during install.
- Follow along or right above the etched guideline all the way through to separate the panels.
This technique leaves enough material to wrap the entire side of the vehicle. Aura Vinyl vinyl wrap features a PET backing for reduced orange peel and a cast polymer hybrid build with German-made adhesive for easier repositioning.
FAQ
How do you save vinyl material when wrapping a car side?
Lay out the vinyl sheet with three inches of excess on the front and rear. Cut the extra side skirt piece off the top and etch separation lines with a Snitty tool to preserve larger sections for the doors.
Why is the pillar cut as a straight piece?
The pillar is cut as a straight strip rather than along a curve because the installer can curve the vinyl to match the vehicle bend during application.