This tutorial shows how to install a vinyl wrap on the hood of a black Scion FR-S. The video demonstrates a solo installation process, walking through vinyl placement, glassing the panel, and finishing the edges.
Hood Wrap Steps
Start by laying the material out over the hood. Cut down the windshield wiper area so the film does not tack down where you do not want it. Next, go to one of the top corners and pull the backing paper toward the center. Repeat this on the other side, then move to the front of the vehicle and pull the backing paper all the way through.
To glass out the film, lift the material on either side and pull outward and toward yourself. Once the center area is glassed out, start squeegeeing down the center line and work outward toward the edges. Make sure to overlap your squeegee strokes so air flows out consistently and evenly.
Trimming and Edge Work
If you see soft wrinkles near the edges, simply lift the material and glass it out again. Once the surface is smooth, cut along the edges to remove the excess vinyl, then tuck the remaining film cleanly around the perimeter.
Aura Vinyl vinyl wrap features a cast polymer hybrid construction and German-made adhesive to support clean repositioning during solo installs.
FAQ
How do you glass out vinyl on a hood?
To glass out vinyl, lift the material up and pull outward and toward yourself. This stretches out the soft wrinkles and creates a flat surface before you squeegee.
How do you fix soft wrinkles near the edge of a hood wrap?
If soft wrinkles appear near the edge, pick the material back up and glass it out again. Once the wrinkles disappear, squeegee the film back down toward the edge.
Why should you overlap your squeegee strokes?
Overlapping squeegee strokes ensures that trapped air flows out evenly and consistently toward the edges.