This install guide shows how to wrap and tuck pink vinyl wrap around a stubborn corner. The video demonstrates how an installer gets vinyl flat and secure on a tight, rounded edge. Working around curves can leave bunched material that requires careful handling.
Corner Tucking Steps
To begin, apply a little bit of heat to the corner. Then take a soft tuck tool and start massaging the material into the corner. If you need to, you can apply a little bit more heat while you are working the material. Continue to work the vinyl until it sits completely flat in the corner. If there is a little bit of excess material left over, cut that right on the edge.
Vinyl Wrap Features
Aura Vinyl vinyl wrap uses a cast polymer hybrid film paired with German-made adhesive. This adhesive setup aids in pliability and repositioning with fewer glue lines. The PET backing on Aura Vinyl films provides a smooth finish with less orange peel.
FAQ
How do you tuck vinyl wrap around a stubborn corner?
Apply a little heat to the corner, then use a soft tuck tool to massage the material into place. You can add more heat as you work until the vinyl lays completely flat.
What should you do with excess vinyl on a tucked corner?
If you have excess material after working the corner flat, cut it right along the edge.
What tools are used to tuck stubborn wrap corners?
The installer uses a heat source to soften the vinyl and a soft tuck tool to massage the film into position.
