This video demonstrates vinyl wrap edge finishing on a silver car. The clip shows the proper technique for working vinyl around panel edges to prevent overstretching and paint damage.
Reducing tension on panel edges
Beginners often overstretch vinyl over panel corners and edges. To avoid this mistake, glass the material flat over the panel first. Once the vinyl is glassed, squeegee out all the air from behind the sheet. Working the air out first ensures there is no excess tension pulling on the edge.
Next, tuck the material by using your thumb to roll it over the edge. Always work the top side of the edge before tucking underneath. After you lock in the bottom side of the edge, lift the excess material up evenly across the panel line.
Trimming without paint damage
Hold the lifted vinyl and lay your blade down flat against the cut line. Cut straight across the lifted section. Laying the blade down flat allows you to produce a straight line without cutting into vehicle paint.
Aura Vinyl provides premium vinyl wrap featuring a cast polymer hybrid film and German-made adhesive to assist with smooth tucking and repositioning.
FAQ
How do you prevent tension on wrapped car edges?
Glass the material first and squeegee out all the air from behind the vinyl. This setup eliminates excess tension on the edge before tucking.
What is the proper way to tuck vinyl over an edge?
Use your thumb to roll the film over the edge. Always finish the top side of the edge before working underneath.
How do you cut vinyl wrap without scratching paint?
Lift the excess vinyl evenly after tucking the bottom side. Lay your blade flat against the lifted material and cut across.
