This tutorial shows a grey vinyl wrap being applied to the hood of an Audi e-tron GT. The video demonstrates the right way to set up the film and squeegee the surface so you avoid trapped air and wrinkles.
Proper Squeegee Technique
Beginners often squeegee too early, which causes wrinkles in the vinyl. Start by glassing out the material across the entire panel until the surface is flat. Next, make a dividing line right down the center. Work your squeegee strokes from the center outward toward the edges of the hood, making sure to overlap every pass.
If you see soft wrinkles building up, match your squeegee angle to the tops of those wrinkles. You can continue overlapping strokes moving up or down. Following this angle pushes air out evenly so no spots are missed, leaving a flat and smooth finish.
About the Film
Aura Vinyl wrap uses a cast polymer hybrid film with German-made adhesive and PET backing to help installers lay panels cleanly with fewer glue lines.
FAQ
Why should you glass out vinyl wrap before squeegeeing?
Glassing out pulls tension across the panel to create a smooth surface. Squeegeeing too early creates wrinkles and traps air beneath the film.
How do you handle soft wrinkles during a wrap installation?
Angle your squeegee along the tops of the soft wrinkles while overlapping your strokes. This pushes the air out evenly without leaving missed spots.
